Why in screw & centrifugal compressor using rolor bearing
Answers were Sorted based on User's Feedback
Answer / guest
rolar bearing is used to reduce the friction between the
cylinder and bearing
Is This Answer Correct ? | 19 Yes | 4 No |
Answer / guest
due to point loads in bearings and rotary mechanism
Is This Answer Correct ? | 2 Yes | 4 No |
Suppose there are two vessels. One of diameter = D and other vessel dia = d. Suppose in vessel with dia D, water is filled upto height H and vessel with dia d is empty. Now both vessels are connected.Water will flow from D dia vesel to small d dia vessel.Suppose after equilibrium height of water in vessel with dia D is h. How much is h in terms of D, d,H etc?
i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.
What is the pressure of fuel oil on main engine and diesel generator?
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
if there is self ignition in petro engines then why is the need of spark plug in petrol engine ???
1 Answers Velammal Engineering College,
What is the function of Clapper box in a shaper?
11 Answers HAL, Seven Rings Cement,
Write the relation between EER , COP , SEER in airconditioning?
What is difference between centrifugal compressr and screw compressor?
Refrigeration cycle works on?
can we operate a deseal engine on outo cycle if no why??
Hi, How I can calculate mass flow rate for an axial fan with diameter "400mm" and speed 1500RPM? thx
can anybody send me syllabus of Mumbai RRB for section engineer(mechanical) post