Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) In dc motor starter there is less voltage required for holding contactor that's may why it is called no volt coil. but in ac starter why holding contactor is called no volt coil.
JSW,
2 5653If there is unit power factor in a power house and a capacitor bank used in a factory at resistive load . In this case, will there leading power factor in power house across that factory.
2 4690there is a # KVA Transformer of 11 KV/440V, in simple(not use formuia) how can you calculate it's HT & LT side current.
5 23937
i am satish i want to preapare for group-1 exams so please help me?
what are the ffactors you considered choosing the course?
Explain about Wardrobe Planning.
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
How can heat be applied to acrylic?
Why is remote backup preferred to local backup?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
How would a salt and water solution clean a penny but a vinegar and salt solution will not clean a penny? What is the cause of this?
please send me last five year papers for my electronic and communication branch as i have completed my graduation in diploma.
In explain what way is the voltage follower a special case of the non-inverting amplifier?
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
A rectangular sheet dimensions a x b is to be made into an open-topped box by cutting a square of side h from each corner and folding the 4 sides up. Find the value of h which allows the maximum volume of the box?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
Give an introduction to bourden pressure gauge?