If there is unit power factor in a power house and a capacitor bank used in a factory at resistive load . In this case, will there leading power factor in power house across that factory.
Answers were Sorted based on User's Feedback
Answer / prasanna raj
I dnt thnk so. Most of the loads used in power house are of Inductive only which have lagging power factor. If in case capacitors banks are used, Capacitors inspite of having leading power factor discharge & drop the power factor once the loads are connected to capacitor banks. I think it will not maintain leading power factor once capacitor banks are connected to resistive loads (in case) but will be lesser or nearer to Unity power factor.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / pradyumna chandra panda
I would like to ask above question.
Is This Answer Correct ? | 0 Yes | 2 No |
What will hapen if we connect more capacitors than required for powerfactor control? Exactly what will be the effect on power system?
WHAT IS NORMAL VECTOR GROUP USED FOR DESIGNING OF TRANSFORMERS??
What Should I Know about Metering, Switchgear and Panels?
What is different between MCB & MCC & isolator switch
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
how we select HRC FUSE ?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
Rotor is taken away from three phase induction motor and three phase supply is given to the stator.What will happen?
i want to make an elec generater with only 12v car battery car alternater and 12 volt motor ..... will the battery charge and give power at same time with out over charging the battery?
when voltage gets down the current of motor increases. but according to Ohm's law voltage is directly proportional to current. plz explain
4 Answers Maruti Suzuki, TATA,
To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?