How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
NA,
1811While connecting the flood light plug on to the 415 V distribution panel,there was spark and the cable got burnt. Three ignitors of the flood light also burnt of. The lamps are of 400 W (total 6 lamps) connected through 1.5 mm2 cable. The plug was immediately removed from the circuit. There was a 30 mA RCD connected and a 250 A MCCB; however both did not trip. What could be the possible reasons for the circuit devices not to trip?Can someone assist please. Additional info if needed can be provided.
2 3559Dear All, How can I make 5VDC with 500mA current rating from our 230VAC. Can anybody help me with different answers? I am Ansari-9820016777.
TCS,
4 4745What is the main difference b/t Earth leakage relay & Earth fault relay.I want protect my LT panel(Distribution Panels)which relay have to propose.......
1 3603hi dear friends i have applied RRB exams SE so i need previous year question papers please send to my mail id santhu.hpt@gmail.com
1435What is the spacing of chairs in reinforcement steel.If it is written in IS 456:2000 then tell me the page number.
2 6559what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
NTPC,
1642
how to control pid
What kinds of pipes are used for steam lines?
explanation of mesh bus bars
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
what are the interview question asked in wind mill about electrical
what is effect of length of air gap on performance of dc motor and generator?
Why does mode in arm in cpsr have 5 bits instead it can have only 3 bits to define all the 7 modes?
How to get KWH,Voltage & current datas from 2KVA hybrid inverter to my computer
Explain the different printing techniques?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
Define negative logic.
what is difference between speed mode and torque mode in motor?? explain in simple words please.
What are the advantages of projection welding over spot welding