If one d.g. is unable to take full load of system, then second d.g. will take care of partly Load.for this condition RPM of both DG set should be equal.By using Synchronization panel RPM of dg sets are match, is it true?

1 Answers  

---

How can we calculate the power factor of an electrical appliance ? Is there any formula ? Is there any meter around to calculate it ? And how to use that meter ? thanks

2 Answers   Essar, Philips,

---

How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.

2 Answers  

---

I hv a question regarding power factor improvement just after transformer. I request you to reply me plzz. thank you sir. My friend has a small unit of fabrication. in his factory the main load is a welding machine, lathe machine, grinding machine. this load is not continuous type. now our electricity board has installed 16 KVA, 11000/433 V transformer for our factory. In the energy meter (trivector meter) at LV side of transformer, i hv seen power factor value of 0.15 only when only 3 KW load was flowing. Further electricity board has suggested to install 4 KVAR capacitor at LV side after energy meter. Now my question is that if we permanantly install and switch on 4 KVAR capacitor after energy meter, during some load on transformer and also without any load on transformer, wht will be the power factor shown in energy meter?i dont want to get any penalty by electricity board, so plz suggest me if i can permanantly install and switch on the 4 kvar capacitor or not at LV side of transformer just after energy meter? Thank you again and awaiting for ur positive reply soon.

9 Answers  

---

Squirrel cage induction motor has constant A slip B stator current C rotor resistance D speed at all load

1 Answers  

---

how to calculate the minimum permissible limts of insulation resistance of switchyard equipments

1 Answers   HVPNL,

---

1 HP = how many kw

9 Answers  

---

how to calculate Transformer loss?

1 Answers  

---

A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?

0 Answers   Siemens,

---

Explain mechanical rotational system?

0 Answers  

---

How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?

0 Answers   ONGC,

---

Why winding temperature ct placed in B-Phase of the transformers?? 

3 Answers  

---