how can u say about the line by looking at the tower ? {voltage rating of the l

how can u say about the line by looking at the tower ?
{voltage rating of the line}

Question Posted / madhu

3 Answers
6885 Views
BARC, London, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how can u say about the line by looking at the tower ? {voltage rating of the line}..

Answer / manoj

Each insulator is designed for 11 kV so counting no of insulators on the pole gives an idea about line voltage

Is This Answer Correct ?

8 Yes

1 No

how can u say about the line by looking at the tower ? {voltage rating of the line}..

Answer / jayakumar

each type of insulator designed for some standared voltage
value. Thus the voltage rating of the line depends on
insulator type and the number of insulators.

Is This Answer Correct ?

5 Yes

0 No

how can u say about the line by looking at the tower ? {voltage rating of the line}..

Answer / ujjwol

Just like the other people said, counting the number of insulator will give you the idea of voltage level of the line. If there are 6 insulators, it is basically 66 kV and if there are 9 insulators, its 132 kV and so. If the tower has horizontal configuration , then u can almost predict that the voltage level exceeds 200 kV. It is because horizontal towers are used for voltages exceeding 132 kV ,to reduce the height of tower.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?

0 Answers

WHY AIR COMPRESOR IS STARTED UNLOADED

3 Answers

How to design the blower for motor? how to two blowers connected in motor?

1 Answers Ashok Leyland, TATA,

What are the limitations of Kirchoff's laws?

0 Answers

In a 132KV Grid Station where voltage level is 132KV, here, why the rating of Surge arrests installed 120KV ?

1 Answers

we have a 2000kva step down transformer at our site. The HT side is charged from 22000V. So the primary current will be 52.48A. So why the HT breaker(SF6 ABB) is rated of 1250Amps ?

2 Answers

how can findout cable fault Location only useing MEGGER

3 Answers

In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?

0 Answers

what happens when we give supply to the secondary of a transformer ?? for example 415v(pri)/110v(sec)

2 Answers

How to calculate load taken by a cable?

3 Answers

why did youi choose this career?

0 Answers KTB, ONGC,

What happen if field ckt is open when a sailent pole alternator connected to infinite bus

3 Answers Bhel, Nilkamal,

For more Electrical Engineering Interview Questions Click Here