If 440 V supply has given at the secondary winding of transformer at that time

If 440 V supply has given at the secondary winding of
transformer at that time if we apply 11 KV at primery then
what will happen???????

Question Posted / shri..

4 Answers
7536 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If 440 V supply has given at the secondary winding of transformer at that time if we apply 11 KV a..

Answer / s c budhiraja

nothing will happen if rated voltage is applied to both the
windings

Is This Answer Correct ?

4 Yes

2 No

If 440 V supply has given at the secondary winding of transformer at that time if we apply 11 KV a..

Answer / parin

if transformer ratio is 11000/440,and supply is given according to polarity with same power factor then no power flow in sec. so it not damage transformer but if polarity not correct then two emf addition gives high current like s.c.

Is This Answer Correct ?

2 Yes

0 No

If 440 V supply has given at the secondary winding of transformer at that time if we apply 11 KV a..

Answer / kalidass

Well Mr. Buthiraja,U r correct Bcoz in our plant also we
are using 110(Primary)/6.6 Kv(Secondary)Transformer..But We
exported the power to grid through 6.6 Kv side itself...

Is This Answer Correct ?

0 Yes

0 No

If 440 V supply has given at the secondary winding of transformer at that time if we apply 11 KV a..

Answer / ratnagiri

Source should not be given from both the sides. There will
be a severe S.C Fault and the transformer will be damaged.

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

Explain the power rating of a bulb, say 60W, what if the voltage changes

4 Answers

in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?

0 Answers apspdcl,

WHWT IS USE OF VACCUM CIRCUIT BREAKER

4 Answers

what is XLPE type cable

8 Answers Areva,

what will happen if we double the input frequency of a transformer keeping the voltage constant?

6 Answers

What is cp system and why is it required.?

1 Answers Essar,

in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?

0 Answers

why the genearation of electricity always in form of sine wave only ??? why not cosine wave ???

1 Answers

Why Generator rotate only clock wise ?

8 Answers L&T,

what will be the effect on a bulb in case its connetion is change from live and neutral to live and ground??? 1) in case of single phase AC supply 2) in case of DC supply.......???

1 Answers

what is the function of choke and starter in a tube light??

2 Answers

What are test signals and their significance?

0 Answers

For more Electrical Engineering Interview Questions Click Here