Answer / karthik

Megger is used to test the resistance/insulation capacity
between two conductors be it
(*) Phase and neutral
(*) Line to ground.
(*) Phase to phase
For testing using megger

(*) Connect one terminal to the phase and other terminal to
neutral/ground for testing line to ground resistance.

(*) Connect one terminal to phase and other terminal to
another phase in case of phase to phase resistance.

All the nominal value of resistance must be greater than
atleast 1Mohm.

Why the size of transformer decreases if we increases the frequency?

5 Answers   Graphics Engineering,

---

what is phase voltage phase current line current and their usage? provide diagram

1 Answers  

---

How to calculate the breaker's short circuit current?

1 Answers  

---

If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost

1 Answers   ANITS,

---

what u meant of power plant?

5 Answers  

---

what is the differation bewreen kwh & fundamental kwh in electronic trivector meters

0 Answers  

---

Synchrounous motor is three phase motor,but its not self starting .why?

23 Answers   Delta Beverages, KI, L&T, NTC, TVS, Wipro,

---

defination of loads

1 Answers  

---

How to operate a ac chilar plant?

0 Answers  

---

there are a transformer and a motor. both are connected to 3phase, 415 Volt, 50Hz power supply. Both are working with induction principles. Then, why, motor is rotating and transformer is not rotating.

8 Answers  

---

Impedance relay is directional relay or non directional relay?

2 Answers   KSEB, NTDC,

---

What is the difference between alternator and generator?

0 Answers   IOCL,

---