Answer / haridoss

advantage
*conductor cost is low.bulk power can transmit 2wire system.
*not affect the communication line

disadvantage
*complicate to design the filter

Answer / silu pattanayak

Also, following advantages;
1. no frequency mis-match problem and hence helps in Grid synchronization of two different Reason.

2. Better control over power flow by controlling the Load angle.

3. Easy transmission for long distance lines, as there is no Capacitive voltage increment ( due to Ferranti effect ).


Disadvantages:

More complicated and initial cost of the plant is many times higher than that for the terminal equipments of AC stations of same capacity.

What is OLTC AND RTCC and it's function?

2 Answers   Sterling Wilson,

---

explain 100 percent and 95 percent earth faults

1 Answers  

---

1-What is the difference between absorption factor and polarization factor in insulation resistance test in transformers? and why we inject until ten minutes to get polarization factor?

1 Answers  

---

I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.

2 Answers  

---

what happen if ac supply is fed to rotor of the alternator

2 Answers  

---

---

what is vfd?

2 Answers  

---

Why do not we prefer non conventional sources of energy to conventional sources?

0 Answers   Nabard,

---

We have 250 KVAR cacitor bank & our average load is 200kva but our power factor is average 0.66 how can we maintane it? how can we balance our load?

4 Answers  

---

What is the formula to calculate the rating of a three phase miniature circuit breaker

0 Answers  

---

IN MCCB AND MCB TERMINATIONS ARE IN-COMING ON TOP AND OUT GOING ON BOTTOM,IF WE TERMINATED INTERCHANGED TOP AND BOTTOM ITS WORKS?

2 Answers  

---

how to caluclate cable size by Amps

2 Answers  

---

What is the function of attenuator in cro?

0 Answers  

---