How can we say that accuracy of measurement increases by using 3 or 4 wire RTD? because for example: If resistance of RTD element is say r ohms and Resistance of the cable from transmitter to RTD is R ohms And if 4 wire RTD is used, ____._____________________ R ohms | |_____._____________________ R ohms / \ / r ohms \ \ | |______.__________________ R Ohms | |_______._________________ R ohms Then the actual resistance measured will be: Total = r + R/2 + R/2 = r +R Ohms Note: r+R instead of r ohms. hence error

2 Answers  

---

What is the start up procedure of desalter

0 Answers   Reliance,

---

Why hunting will occour in control valve?

6 Answers  

---

what is droop in governer ,type of droop ,how it work

0 Answers   TATA,

---

the 3 most common transmitter protocol being in refinery or qatar gas and aramco.

0 Answers   Shell,

---

what are the use of belew gear in general ??

0 Answers  

---

Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?

0 Answers  

---

How to convert mA into Percentage?

4 Answers   KNPC,

---

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

What are the application of bernoulli’s theorem?

0 Answers  

---

What is loop1 and loop2 in MTS LT?

0 Answers  

---

why magnetic flow meter is not used in thermel power plant operation

2 Answers   JK Paper,

---