For having nonavailablity of 10 Amps fuse, a lineman replace the same with 5Am

For having nonavailablity of 10 Amps fuse, a lineman replace
the same with 5Amps two strand, Do he correct ?

Question Posted / manjunathas puthi. je

4 Answers
5313 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

For having nonavailablity of 10 Amps fuse, a lineman replace the same with 5Amps two strand, Do he..

Answer / gravityguru

connecting them in series will not serve the purpose but
connecting them in parallel will serve our purpose..

Is This Answer Correct ?

1 Yes

0 No

For having nonavailablity of 10 Amps fuse, a lineman replace the same with 5Amps two strand, Do he..

Answer / nagaraj pole

both are same rating but thing is only rating lable changed

Is This Answer Correct ?

0 Yes

2 No

For having nonavailablity of 10 Amps fuse, a lineman replace the same with 5Amps two strand, Do he..

Answer / sree

yes

Is This Answer Correct ?

2 Yes

5 No

For having nonavailablity of 10 Amps fuse, a lineman replace the same with 5Amps two strand, Do he..

Answer / santosh kawade

No.

If 10 amps fuse not available replce the same with 5 amps
two strand is not correct.

Because while connecting two strands in parallel current
distribution between them will not be equal and if one fuse
fail above 5 amps the other automatically fails
subsequently.

Santosh Kawade
9224 69 3116

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

Describe Non I.S. Earth System and why is it used?

0 Answers KPJV,

Why let through energy not considered for ACB breaker while cable sizing?

0 Answers

In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.

0 Answers HAL,

help me with the question that might be ask on the interview for technical position

0 Answers Eskom,

how step up transformer step up the voltage and what is the reason behind it?

3 Answers

As you achieve greater success with the company after some years, Will you like to be a share holder in our company?

0 Answers PESPL,

How to calculate the Short Circuit Impedance in Transformer?

3 Answers

How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com

0 Answers

Describe the test procedure to determine the vector group

0 Answers MPSEB,

WHat is the general checks required for Dry type transformers

0 Answers

It is being often experienced that due to single phasing fault of any source transmission line of any closed loop synchronized circuit all the power transformers with primary stared trips but the power transformer with primary delta wont, why ?

1 Answers MSEB,

What is the minimum insulation value required for a cable between phase to phase and phase to earth of 380 Vac 50Hz circuit, having load arround 800 amps.

2 Answers DEWA, TATA,

For more Electrical Engineering Interview Questions Click Here