Answer / hardik

boiler efficiency= (heat transferred to feed water in
converting it to steam)/(heat released by complete
combustion of fuel)

n(eta)= Mass of steam * (h- H(water))/(mass of fuel *
calorific value fuel)

Answer / srinivas

yes this answer is correct

Answer / harsha

BOILER EFFICIENCY= (STEAM QUANTITY X (STEAM ENTHALPY-FEED WATER TEMP))/(COAL CONSUMPTION X CALORIFIC VALUE OF COAL)

Answer / vinay mishra

DIRECT METHOD
BOILER EFFICIENCY = TOTAL MASS OF STEAM GENERATED * (TOTAL
HEAT OF STEAM - SENSIBLE HEAT OF FEED WATER )/ FUEL FIRING
RATE * GCV OF FUEL

Answer / sunil thakur

boiler efficiency=heat actual used in producting steam/heat
liberated in the furnace
=m(actual evaporartion)(h(heat of steam)-hf(sensible heat
of feed water))/c(calorific value of fuel)

Answer / ub

I am a little confused about the what the symbols mean in Hardiks answer.

n(eta)= Mass of steam * (h- H(water))/(mass of fuel *
calorific value fuel)

What does eta here mean?
What is h? H?

what is meant by cigarcone?

2 Answers  

how to calculate air load of a existing/ new plant before installing a air compressor.

0 Answers  

How to calculate motor bearing life - cycle (life time) (SKF bearing)

0 Answers  

What are carvings in Ajanta Caves? a.Mahabarath b.Ramayana c.Jataka Tales d.Upanishads

1 Answers   HAL, LLB,

Which conducts heat faster steel copper or brass?

0 Answers  

What is differance between qc & Qa? in mechanical field.

13 Answers  

What is the impulse reaction turbine?

0 Answers  

distance between the power generation and the distribution to the application is fixed or vary

0 Answers  

What is the purpose of corrugated furnaces?

0 Answers   ABC Inc, RRB, Siemens,

What is blast furnace

0 Answers   JREW, TATA,

hi friends i am harish and i have a problem plz solve it . . The problem are how to calculate the rpm of mechanical blower if any formula for calculate for this then tell me if drive shaft gear are 40 teeth and driven shaft gear are 70

1 Answers  

Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?

0 Answers