Answer / vijay kumar

P=V * I * power factor
If p.f =1

P=V * I

Power factor means phase angle between voltage &
Current.Angle varies between 0 to 360 degree.The value of
cosine in any quadrant cannot be more than 1.so power
factor is maintained one to get maximum power.

Answer / shyamkr

we know the expression for power factor is cosine of phase
angle between voltage n current is R/Z.
SINCE r never become greater than z since r=sqrt(r2+x2)
so it varies frm 0 to 1.

Answer / jain c

power factor is the cosine of angle between voltage and
current. the range of value of cos lies between -1 to 1. So
there is no chance to become power factor as 2,3,4 etc.

Answer / bala.a

Power factor = consumed power ( Kw )/ Apparent power (KVA )

SO IT IS NOT POSSIBLE TO 2,3.4

Answer / vijaya kumar.m

Power factor means Cosine angle between Voltage and Current
so cosine rang is in between -1 to +1 so power factor unity
means one(1)
For only inductive load current lags voltage behind 90deg
For only capacitve load voltage lag current behind 90deg
For only Resistive load current and voltage both are same
phase

Answer / nimmi

It is often desirable to adjust the power factor of a
system to near 1.0. This power factor correction (PFC) is
achieved by switching in or out banks of inductors or
capacitors.that is the reason the power factor is always
maintained at 1.0 and called as unity power factor.

why inductancce of armature inductance of dc machines is neglected?

2 Answers   APPSC,

If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers   Brigade,

how to control the speed to switched reluctance motor

0 Answers  

ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture

0 Answers   Mukand,

What happen if LV supply is fed to a HT motor?

19 Answers   ITC Infotech, Jindal,

Explain how you intend to work under pressure to meet up with deadline target?

0 Answers  

For what purpose an AVR in generator sensing generator output voltage?and how the sensing is done by AVR?

3 Answers  

I did oil BDV test of 1600 KVA trafo 20KV/400V as per IEC 156. Result is 1) 58 KV 2) 58 KV 3)40 KV 4) 50 KV 5) 58 KV 6) 18 KV. Avr is 47 KV. Can we say oil is still ok even in the 6th test BDV is 18 KV ?

1 Answers  

What is the acceptance value of leakage current in HI POT test

2 Answers   CPCL,

How to calculat size of copper & aluminium ?

6 Answers  

what is the difference between 11kv and 13.8 kv? why we can't used one of these 2 sources?

2 Answers  

X/R ratio in 11kv transmission line is?

1 Answers   RRB,