Is there devices to convert mechanical energy/rotational
energy into electrical energy.......?
PLease suggest me....
Answer Posted / santhosh rapilane
tachometer
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What is the use of single seated valve?
where proximity sensor installed on tank in loading arm application
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
why using negative supply for bentley nevada vibration system ?
Define cryogenic?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Can anyone send most commonly asked interview question in Oil & Gas industry
how to relay switch sense the fault?
how to turbine speed measurement?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
what is the imbustion control loop