Turbo charger driven by.............? and wat its speed
Answers were Sorted based on User's Feedback
Answer / ramalinga raju
Turbo charger driven by exhaust gases of the engine and its
Speed range from 70000-90000RPM
| Is This Answer Correct ? | 41 Yes | 7 No |
Answer / raghavan.s
Turbo charger is driven by Exhaust Gas from engine.Its
speed range varies depending on the capacity of engine. Ex.
for a 6 cylinder engine(Ashokleynald say)the vol. flow rate
of exhaust gas will be more hence Turbocharger of larger
size is required,this Turbocharger has max. speed of
90000rpm...where as for a commercial vehicle say(TATA
indica 1100CC)we use Turbocharger of small Size which has
max. speed range upto 2,80,000rpm.
Raghavan,
Engineer R&D,
Turbo Energy Limited,
Chennai.
| Is This Answer Correct ? | 14 Yes | 4 No |
Answer / rishi
its charged by the exhaust gas and the speed depends up on the pressure of the exhaust gas it does not have a constant speed
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / vijay bansal
turbo charger driven by exhust gasesof the engine and its
speed range 70,000RPM to 1,40,000RPM.
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / manikandan
Turobocharger is driven with Exhaust gas(diesel,gas engine) from engine.speed range depents upon engine capacity(like car engine To heavy diesel power plant 50 mw engine( 2/3 turbo in engine)).minimum speed of heaviest turbocharger is 5000 rpm and weight approx 15tonnes(1 t/c).
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / nadeem
it's self driven........its speed is around 75 to 90
thousand RPM
| Is This Answer Correct ? | 19 Yes | 19 No |
Answer / mohamed ali
Turbo charger driven by exhaust gases of the engine and its
Speed range 99000RPM
| Is This Answer Correct ? | 3 Yes | 3 No |
What is brain of the computer?
why it is difficult to make heavy cuts if a form turning tool is complex in shape?
difference between steam hammering and water hammering
Hi i am having 5 yrs of exp in Proe wildfire,Anybody have the jobs related to Aerospace
what are the applications where bearing should not be used though it can be used(economy may be 1 of the reason)
why can't you use centrifugal pumps for pumping viscous fluids?
What will happen if we rotate the horizontal plane in anti-clock wise instead of clock wise and make the drawings in 2nd and 4th quadrant?Why the horizontal plane always rotates in clock wise?
how to guess size of hole according to size of bolt,say M12?
sir i need ongc old technical test papers can u send me immediately
why there was 17 stage of compressor in the most of the gas turbine . depending on what?
if u r sailing on aboat with ur boss n a customer n d boat is sinking whom wud u save if u had only one choice to save betn boss n the customer???why???
Will a steel cable become longer if it is heated while under load?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)