Hello-I know this not an engineering question,I am working in gulf & i wan

Hello-I know this not an engineering question,I am working
in gulf & i want to do correspondence diploma in
instrumentation,can any one give me the address of any
university in which this courses are available.

Question Posted / tauhid

2 Answers
5324 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Hello-I know this not an engineering question,I am working in gulf & i want to do corresponden..

Answer / rajkumar

http://annamalaiuniversity.ac.in/distance_edu.htm

Is This Answer Correct ?

4 Yes

0 No

Hello-I know this not an engineering question,I am working in gulf & i want to do corresponden..

Answer / haridass

Vinayaga mission, Rajasthan University such like these
groups conducting diploma courses in chennai and all over
india, we can do the correspondence diploma through these,
classes not compulsory. Search "vinayaga mission" in
google.com.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

What is the working principle of oxygen analyzers(zirconium oxide type) used in CFBC boilers?

3 Answers Bajaj, Kohinoor, Wartsila,

What is loop checking ?

10 Answers Kharafi National, Petrofac, Samsung,

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.

1 Answers

HOW TO DO PERFECT CALIBRATION OF DIFFERENTIAL PRESSURE TRANSMITTER FOR CLOSE VESSEL TANK LEVEL PURPOSE ???? AND HOW TO MAKE ZERO PRESSURE ?? Rosemount 2051 Pressure Transmitter with HART® Revision 5 and 7 Selectable Protocol BIENG USED !! HOW TO CALIBRATE FIELD SIDE DPT WITH THE HELP OF SPAN & ZERO PUSH BUTTONS ??

1 Answers Bhel,

What is diff between Ingral orifice and simple orifice?where it use?

3 Answers

What is the purpose of LO Overhead tank in turbines.

0 Answers ADMA OPCO,

A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.

1 Answers

How to check electrical health of Vibration probe?

1 Answers QAFCO,

Hi, I'd like to know the purpose of MOS (maintenance override switch). At site, these switches are installed in a stanchion with the transmitter (connected to ESD). thank you.

3 Answers Adani, Adani Wilmar,

What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers

what is intools software

2 Answers

how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??

0 Answers

For more Instrumentation Interview Questions Click Here