Interested to Buy Any Domain ? << Click Here >> for more details...
A flange is used for instrument connection for a system with a
design temperature of 316C (600F) and a design pressure of
1000 kPa (145 psi). What is the class rating of the flange to
be used for this application? Explain your answer
- 0 Answers
- 2537 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
How much voltage we get between two wire of 4 to 20 ma output? Is this voltage up or down respectvice to 4 - 20 ma ?
Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???
why we set -10 volt in vibration sensor output,why not +10 volt
how to calibate level transmiter ?range -150 to +150.what is the zero and span?
difference between accuracy and precision
2. What is ultrasonic flowmeter?
please tell me how to convert double acting ytc positioner yt-1200 into single acting ytc positioner ?
Why we use 250 ohm resistor in series with HART protocol communication?
13 Answers Chemtrols, Instec, Sabic,
what is formula mv convert to temperture
can you provide me full detail about instrumentation in ONGC??
Which is your favourite subject & explain any one topic of it.
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
