Answer / k.prakashchandra

To alter the secondary current of CT to the requirement

Answer / ullas k prabhu

To set the time of operation of the relay as soon as the
fault is detected...It will be usually interms of
milliseconds.....

what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.

0 Answers  

---

How to run a three phase motor into single phase........

0 Answers   Oil India,

---

what is the difference between high impedance REF & REF, same high impedance differential protection & differential protection for Power transformer?

1 Answers  

---

What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.

0 Answers   DAE, Hindalco,

---

HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?

0 Answers   TMB,

---

why America use 60HZ 110V?

4 Answers   Kalindee Rail,

---

What is dielectric loss?

0 Answers  

---

what are the type of transformer?

4 Answers  

---

What should be the setting of an earth fault relay.

2 Answers   HP,

---

which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured

0 Answers  

---

what is the meaning of servo motor. In trains, what type of the motors we are using at the bottom of each compartment

5 Answers  

---

I have 500A load (WHICH IS SEPARATE MDP PANEL),an MCC panel with 4000A Breaker.Already I have 2500A load.Can I connect this load directly to the Busbar since I have PROTECTION IN MY MDP Panel ?

4 Answers  

---