Answer / matt

Let through energy is the amount of energy that will be let though in a short circuit condition. The let through energy (I^2t) is calculated from the fault clearing time and the trip multiplier, which is obtained from the MCCB manufacturer. Let through energy is useful in sizing downstream cables.

Answer / rohit

Let through energy of MCCB or Fuse is the energy required
for the operation of magnetic coil (in case of MCCB) or
fusing the metallic wire of fuse.
this shall be as small as possible for the protection of
downstream electrical equipment such as cables, motors etc.

Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.

0 Answers  

---

anybody can give the voltage value for 1M ohm

2 Answers  

---

What is disadvanage if power factor goes to in leading..?

0 Answers  

---

what is high and low cut off voltage of BB and DG at SPS????????

0 Answers  

---

How servo stabilizer works.

0 Answers  

---

What is LT? And specify the range of voltage?

10 Answers   HSL,

---

Why should The rating of 11 kV DO Fuse is in mulyiple of hundred(200 Amp. 40 Amp, etc) Ampere wheareses the its fuse elemnt has rating in just few Amp (< 12 Amp)? ( Is it jusy beacuse of factor of safty).

1 Answers  

---

What is the use of insulation tester and how it is to be used.

2 Answers  

---

what is meant by k-rating in isolation transformer?what is k9, k14 stands for?

0 Answers  

---

Safety of on line ups

0 Answers   Bhushan Power Steel, GE,

---

What is the diffrence in between Class PS & Class 5P10 for CTs

7 Answers  

---

how many frequent start/stop operation possible in case of HT MOTORS.

5 Answers   DVC, Steel Plant,

---