at work we have a 3 phase motor but on testing one phase isnt getting a reading.

at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.

Question Posted / tom

0 Answers
1670 Views
iGas, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

Please let me know when replacing electromechanical Relays for protection of generators with sr489 multilin Relay, then there is no need to use 86 master trip relay Too. I am wondering this multilin relay has no contact to Stop breaker reclosing as 86 does

1 Answers Neucel,

while calculating demand in my company the present load in kw is 212.... there 125kvar capacitor bank is installed by spliting as 50 in departments...the diasplay in panek biard shows 175kw... how could we know the amount of kvar used to compensate the kva

1 Answers

define bilateral network and unilateral network? give an example.

3 Answers ABB,

How to check it good or bad capacitor

4 Answers IMD, ST,

1) What is difference b/w impedence relay and differential relay? 2) what are substations equipments? 3) what is difference b/w circuit breaker and isolator? 4)what are the types of circuit breakers? 5) which medium is mostlty used in circuit breakers and why it is used?

1 Answers NTDC,

how to calculate the multiplying factor for energy meter with CT ratio given

23 Answers Bhel, Dalmia Group, DIFC, Fedco, Hindustan Unilever Limited, Lupin, MahaDiscom, MAL Pakistan, Myunghwa Automotive, Panchshil Infrastructure, Regala, RVPN, VIPL,

What is Procedure the procedure to select CT's & PT's in 66kV and above substation?

3 Answers Infotech, Vijai Electricals,

sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"

0 Answers

upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.

0 Answers ABC,

specific gravity of a battery?

6 Answers

Why use windmills is squirell cage generators?How to calculate the slip ?

2 Answers

I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.

0 Answers

For more Electrical Engineering Interview Questions Click Here