flush point of transformer?
Answers were Sorted based on User's Feedback
Answer / aamod tripathi
FIRST OF ALL THE QUESTION IS NOT CORRECT
THE QUESTION SHOULD BE" FLASH POINT OF TRANSFORMER"
THE FLASH POINT OF TRANSFORMER IS THE HIGHEST VOLTAGE WHICH
TRANSFORMER CAN BEAR WITHOUT CATCHING FIRE OR GETTING
DAMAGED
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / abdul aleem shaik
The parameter flash point is of transformer oil but not of the transformer.
Is This Answer Correct ? | 1 Yes | 3 No |
What happen if we have run 415 V,50Hz designed motor at on 480V,60HZ
What are difference between earthing switch and earthing truck ? What is the operation philoshopy of earthing truck ? Wht are the component of earthing truck ?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
what are the safety of chiller.
give me applications of sequence bridges . (used in 3 phase un balanced systems)
If the load of transformer is getting more than its rating,,,than how to overcome this problem? Suppose thee rating of transformer is 315kva and the load is going beyond than the rating say around load: 352kva... Than how can we solve this problem without deducting the load.
WHY LINK NOT A FUSE IN AC CIRCUIT
why is only master neutral contactor is made to switch in synchronization of dg sets
what is difference between power transformer and distribution transformers
for selection of transformer we will considering 5 to 6 times of starting current of higher rating motor connected to secondary side. according to process wise we will start the motors gradually suppose if we will start 15 to 20 motors at a time wat will happen?
One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
what is mean by hormonics & surge? and it's effects?