Answer / manu

just connet to 2 windings

Answer / alshaikh

You can connect the windings of the transformer in open star (wye) to get three lines output.
You have two lines so just use two windings

2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping

0 Answers  

---

electricity requires a medium to flow and it cannot flow through air. so how does lightning come to earth through air without any medium?

3 Answers  

---

how to calculate 'In'in a system?

2 Answers  

---

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers  

---

Ohms law explain

1 Answers   Hetero,

---

what is resticted earth fault protection ? how did it protect & work in power transformer

3 Answers  

---

what is the job description of a LOW CURRENT ELECTRCIAL ENGINEER in a industry?

1 Answers   BTAT, Powercraft, Prince Glass, Sterling,

---

how much current take 16sq mm Cable

2 Answers  

---

Define the overload capacity of the motor?

0 Answers  

---

why elcb used in circuit

4 Answers   ABB,

---

advantages & disadvantages of Lagging and leading power factor .

0 Answers   KMSC,

---

what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?

0 Answers   TNEB Tamil Nadu Electricity Board, Vestas,

---