Answer / abzouk

Basically one(contractor) has to rework on the
modifications that can occur due to trials on the site by
the client.

Answer / vinay kapoor

THE DUTY OF THE BUILT ENGINEER IS TO DEVELOP THE QUALITY OF
THE PAPER, AND THE MOISTURE OF THE PAPER

Someone Please tell me what are the Pre-Commissioning activities in a Thermal Power Plant for an instrumentaion Engg.

0 Answers  

---

whats the reason for control valve not installed -90degree (down position)

1 Answers  

---

what is the difference between hub and switch?

6 Answers  

---

we have LPG spherical Tank and we want to install DP Xmtr for level measurement.below are the physical measurements Total height of tank is 1850 mtr but 0% level is 1000mm above bottom and 100% level is 450 below upper side.What is the LRV and URV and please mention the formula .The SG of LPG is 0.53 and Wet Leg method will be used.

7 Answers  

---

what is intools software

2 Answers  

---

thermocouple output is AC OR DC??

17 Answers  

---

Hook up resistance decade box to temp.transmitter.

0 Answers   CCIE,

---

in a electronic controller why we are using 250 ohm resistance in input signal?is i/p is necessary in control valve when we are using electronic controller give details?

3 Answers   IOCL,

---

rtd principle?thermocouple principle?

5 Answers  

---

How is plc installing done

3 Answers   L&T,

---

Calibration procedure for water rotameters

0 Answers   HPCL,

---

what does it mean an active front end in vfd plz explain it briefly

0 Answers  

---