Answer / shanth

its a 100 mW power plant switch gear is 11kv.how we can use
11kv sysytem for a 100mw planrt it will result in huge
losses.any way to answer this question it would be 200MVA
transformer and 11kv siwtch gear

Answer / digambar

1.rated current
2.sc capacity
3.sc capasity withstand time
4.cable sizing

Which type of gas used in cylinder (VCB)?????

15 Answers   ICSA,

---

what is acceptance test in electrical engineering.

0 Answers   ABB,

---

If the neutral wire go pass through the core balance current transformer? If yes then why? and no then why?

2 Answers  

---

If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost

1 Answers   ANITS,

---

how load of a turbo generator can be increased

0 Answers  

---

---

What is meant by cold loop test in instrument

0 Answers   Transnet,

---

why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?

0 Answers  

---

break down of electricity is more in summer or in winter ? give reason

4 Answers  

---

Plugging is a phenomenon to= A braking the motor B to accelerate the motor C to run IM as generator D to start the motor

0 Answers  

---

what is the effect of constant power factor to the voltage regulation

1 Answers  

---

factor to be considered for bus bar design

0 Answers  

---

what is a reactive power? what is the relation with power factor?

0 Answers  

---