Answer / kapil

capacity of control valve (cofficent factor)= Q/(Delta P/d
or roho)1/2
Q qauntity of flow rate.
Delta P is Diffrential Pressure =input -output
d is density of liquid.
then u can find out capacity of control valve

Answer / informative

Rated capacity of control valve Cv is what we get through
series of experimental interpolation and by manual
calculation else by series of derivations.

Answer / smart_dude

max capacity of control valve is max value of cv that you
can use at max opening on control valve here we get max
flow rate also
but for everycontrol valve a small amount of margin is
recomand so rat5ed cappicty is abt 90 to 95 %age of full
capacity

what is the protection system in solar turbine compressor

0 Answers  

---

what is difference between call out and call log

0 Answers   Petro Rabigh,

---

What is the diffrence between ff tx and non ff tx

0 Answers   Jindal, Rosemount,

---

why generation of syncronized generator increases when frequency of grid is less then 50Hz & generation decreases when grid frequency goes up from 50 Hz, as comparision with set value entered in govering panel?

1 Answers  

---

What is the maximum distance limit of 4-20mA and 0-10V DC standard signal transmission ?

3 Answers   BARC, ME,

---

what is the difference between dcs & plc

2 Answers  

---

Explain plc level and its type?

0 Answers  

---

what are the values of fuel flow rate in various places in boiler.

0 Answers  

---

What is the relation between electronics & instrumentation

2 Answers  

---

please send me gail format if u have... please help me if u can...

1 Answers  

---

What is loop checking ?

10 Answers   Kharafi National, Petrofac, Samsung,

---

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers   Siemens,

---