Answer / rajesh.

Potential contact means voltage is present on the point. As and when this point is make contact with another point the current will pass and circuit will draw current to load. Example relay contacts, electrical contactors etc.

Someone Please tell me what are the Pre-Commissioning activities in a Thermal Power Plant for an instrumentaion Engg.

0 Answers  

---

why need 3 element system in power plant? if it is not there then what l happen?

5 Answers  

---

What is the difference between HMI and Scada?

4 Answers   Schneider,

---

What is the difference between uv and ir scanners? and what is the workig principle of both

0 Answers  

---

How to Calibrate Temperature Switch in field

0 Answers  

---

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.

5 Answers   MOL,

---

the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove

0 Answers  

---

What is transmitter

2 Answers   GNFC, QNFS,

---

What is Droop? What is Step/Gradient Limiter in Turbine Governor control?

0 Answers  

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

0 Answers  

---

For a diafhram 1.5 d =kn(p-p0) D4 Where d in deflection in inch k=constant n=no of capdule (P-P0)=Applied pressure in psi D In active dia at capsule. -1.5 d=k to p d being constant -1.5

0 Answers   L&T, Shiv Tech Marine Control,

---

Transducer Input 0 to 230 v ac Output-0 to 10vdc Receiver Input 0 to 10 vdc and Output 4 to 20 ma How?

1 Answers  

---