Answer / gajendran.al

Bulbs [devices] for AC are designed to operate such that it
offers high impedance to AC supply. Normally they have low
resistance. When DC supply is applied, due to low
resistance, the current through lamp would be so high that
it may damage the bulb element.

Answer / usmanaslam271

If bulb's rated AC voltage is 220 volts then it will work
on 220 volts DC as well.

Answer / rajendran

if we give to the tube light that is FL lamp it will not
glow since since there is no ballast function...

if it is an 220 V incandescent lamp it will glow normally

Answer / prateek sharma

The bulb will glow just fine but in case of an Tubelight ,
it will light up initially, but due to loss of inductive
action towards the DC an excess current will flow in the
low resistance path f the tube so formed and will draw
excess current resulting in whatever it will lead to.

Answer / ayush verma

It may damage the bulb element

Answer / amir wagdarikar

As in tubelight there is a inductor so the property of
inductor is to oppose dc and pass only ac bcause this reason
the tubelight wont light

Answer / priya wani

It will depend upon the ac & dc resisitance of the bulb.

Answer / ranveer singh

nothing will happn only bulb will blast.

Answer / osayamwen osasere anthony

if u give a 220v dc to a bulb whose rating suppose to that
of 220v ac, i think the bulb wont glow unless a higher dc
source which as a higher voltage value more than 220v ac.

For two systems transmitting the same amount of real power, the system with the lower power factor will have higher circulating currents due to energy that returns to the source from energy storage in the load.???

0 Answers   Bhel,

If the (Motor control center)Panel work on field the relay used in panel in the case this will be damage and no indication provide on panel.fault occur in panel and MCB will not trip. how happen the relay damage in panel and what effect of panel.

1 Answers  

what is the function of step up transformer?

2 Answers   DEWA,

Why the cost of CT increases with the decreasing of its CT Ratio (Technical Reason)?

2 Answers   Vedanta,

i wasted one year for the job after completed my btech what can i say about 1year time in interview

0 Answers   Infotech,

what are the types of control systems to control the speed of the motor??

1 Answers  

what is self commutation how a thyristor discharges through a capacitor and inductor

3 Answers  

what is the effect when the shunt field winding is opened in dc shunt motor (i) at the time of starting ? (ii) in running condition ?

4 Answers  

a 120 60 watt incandescent lamp has to be operated from 50 c/sec 1 phase ac supply. in order to do this a circuit element has to be connect in series with the lamp. which one of the following sries element is preferable.

1 Answers   SSC,

Why 11KV/440V distribution supply use for Domestic use?

3 Answers   Essar, Getco, Nissan,

What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?

0 Answers  

How to calculat the size of copper& aluminium wire ?

5 Answers   Hindalco, IOCL,