why petrol engines have more power than diesel engines of
same capacity?
Answers were Sorted based on User's Feedback
Answer / syed waqas hashmi
hi Pushkar
Thanks for correcting me. But dont you think that power also
depends on combustion ? Think it practically, if most of the
fuel combust then it exerts more pressure on piston, and
more amount of power you get. This is what i am thinking.
| Is This Answer Correct ? | 1 Yes | 7 No |
Answer / girish.s
because in petrol engines the spark ignition produces a
faster stroke hence more power is produced,whereas in C.I
engines this is absent.
| Is This Answer Correct ? | 2 Yes | 8 No |
Answer / nobody
I think you are all wrong. A diesel engine will produce more
power then a gas engine due to higher compression
| Is This Answer Correct ? | 5 Yes | 12 No |
Answer / syed waqas hashmi
Assalam o alaikum.
In my opinion the rate of power depends on combustion. In
S.I engines more amount of fuel get burnt as compare to
diesle engine. The more the feul burnt the more amount of
power you get. If you think that my answer is wrongs so
please tell me i will be thankfull.
| Is This Answer Correct ? | 4 Yes | 36 No |
Answer / anil
in petrol engine heat rejection is less for given capacity
so it gives more power
| Is This Answer Correct ? | 2 Yes | 39 No |
Answer / mv
Because in a Petrol Engine (SI Engine), there is 1 power
stroke in every revolution of the crank shaft. But in a
diesel engine (CI Engine) there is 1 power stroke in every
2 revolutions of the crank shaft.
| Is This Answer Correct ? | 10 Yes | 126 No |
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What is the difference between heat capacity and specific heat of a material ?
how u 'll ,,, shout if anyone beaten u ?
can i get Mahagenco sample question paper?
y we are used oil in the dead weight pressure tester
difference between lead screw and ball screw???
what is an function of air cell bag in air cell conservator
Why RPM cum hour meter connection is not possible in water cooled DEA set. Is there any problem in sensing?
The capacity of the compressor is considered to be maximum when the temperature of the air is a.Maximum b.minimum c.moderate d.
why does cycle rim dont bend even in heavy loads???????
What is extrued aluminum?
Where is the expansion tank located?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)