What are the difference between these terms ? e.m.f,
voltage, potential, potential difference, current etc?
what are the difference between these terms ?
(electromotive force) e.m.f, voltage, potential, potential
difference, reference potential, reference potential
difference, current.
How can i explain and describe these all terms in single
line each and little more explaination too
thanks
Answers were Sorted based on User's Feedback
Answer / arun
When conductors cut magnetic field e.m.f get induced in it.
Voltage is the difference of electric potential measured in
between same point of a conductor or at different points.
Potential difference in between any two points is called as
voltage- same as above.
Current -Flow of electrons in a conductor or when a load is
connected in a circuit there will be a flow of electron
from high potential point to the low one.
| Is This Answer Correct ? | 16 Yes | 3 No |
Answer / karthik_elec
emf : electromotive force means voltage
voltage : the potential different between the two end of
the conductor that tends to create an current flow,
potential also voltage, definitions are same. or
the electrical presure applied to the electron to move one
place to other means voltage
Potential different: this is defined with respect to any
twopoints and it is measured in volts. numerically this is
equal to the work done in moving a coulomb of charge
between the two points.
current : the flow of electron from one place to other
place when electrical pressure applied it means current
| Is This Answer Correct ? | 1 Yes | 1 No |
What core magnetic balance test of transformer? How to do this test in a three phase Star star (star-LV, star-HV) transformer? How to measure and where to measure?
I want to replace the 3 KW DC motor with AC motor so what should be the rating of AC motor? Details Of DC motor to be changed with AC are - Kw - 3, Vf - 310, If - 0.15, Va - 400, Ia - 13, RPM - 2400
Is it possible to measure the voltage of a battery from a single terminal?
What is Isolation Transformer???
If our power factor is lagging then who is in profit? I mean consumer or Supplier!
What is the approximate percentage of Si content in transformer core(CRGO-Cold Rolled Grain Oriented)? Why it is kept so low?
What is Load sharing of Transformer ?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
why we use only sine wave in ac why we do not use other wave forms
What's difference between a400amps lt contactor and a400amps lt circuit breaker
Which is the largest hydropower station in the world?
how does it help for selection of a transformer.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)