what is meaning volt-hz ration,where is necessry tomaintain
and why. specialy during increase the power of generator.
Answers were Sorted based on User's Feedback
Answer / bijay
V = 4.44 F X PHI X N
TO INCREASE V AT F=50HZ,
SPEED OF GENERATOR IS INCREASED WHICH INTURN WILL INCREASE
THE FREQ. ALSO.
FOR THIS REASON DROOP CURVE IS FOLLOWED.WHICH PROVIDES A
STABLE SYSTEM.
FOR MORE EXPLANATION REFER BOOKS ON GENERATOR STABILITY
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / felixraj
it is necessary to maintain in all magnetic circuit to avoid
saturation.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / gbs
V/f determine the overfluxing condition..
normally its used for over excitation condition in generator protion. if v/f increases core will saturate.
Is This Answer Correct ? | 0 Yes | 0 No |
condider as 100 w lamps glowing . for completing a one unit how much time it should glow
What is slip in an induction motor?
WE HAVE A LOAD OF 55KW MOTOR ITS VOLTS 380 3PH AND ITS TAKING 100AMPS (ITS FULL LOAD IS 105AMPS)AND ITS CABLE IS 4CX50SQMM ,NOW ITS GETTING ABNORMAL HEATUP IN CABLE,PLZ TELL WHY ITS HEAT-UP?(CABLE LENGTH IS 15 METERS ONLY)
what is the operation of UPS ? can any one answer me?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
3. What is Impedance Voltage in Transformer?
16 Answers KESC, L&T, Torrent Power,
How you calculate the repturing capacity of a HRC fuse
What is LT? And specify the range of voltage?
why single phase to grd test in HV cable?why not 2 phase at a time?
what is mean by current
one KVAR takes how much amps, and how to add power capacitors to electrical panels, for example if one of the MCC drawn 800amps means how much KVAR required
What is difference between Electrical & Electronic Device?
7 Answers AZ Engineering, Vodafone,