In a Waste heat recovery boiler feed control valve is after
the economiser where as in auxilary boiler feed control
valve is given before the economiser.why?
Answers were Sorted based on User's Feedback
Answer / devanesan
I am not worked in WHR Boiler eventhough the Control valve
after eco. is safe design because the eco coil always with
fluid. tube starvation will not happen. it may be due to
material of eco. coil.
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / magesh
Where have you seen a Feed Control Valve after Economiser in
WHRB?
If it is located after economiser, there is no purpose in a
feed control valve. Usually feed control valves are placed
before economisers in all boilers, so that feed water can be
controlled according to the power requirement. Once it
enters Economisers directly it will go through drum. We
cannot control thereafter. If u still need any explanations,
just mail me mageswaran.c@gmail.com
| Is This Answer Correct ? | 1 Yes | 6 No |
what is mean by CONCENTRICITY? how it is measure?
11 Answers Greaves, Maha Enterprises,
RRB exam qustions.
what is exactly peripheral velocity in case of two meshing gears?
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........
What are the causes of main engine black smoke?
min work in a compresor is possible when the value of adiabatic index n is equal to a).75 b)1 c)1.27 d)1.35 e)2 what is adiabatic index.
Types of pressure
2 Answers ABC Inc, RRB, Siemens,
how 2 prepae for technical aptitude? suggest me any books r
What is the deff betwen Two stroke engine & Four stroke engines. Difine Theoretcally & Practically.
How to calculate the HEAT RATE of a boiler and a HEAT RATE of a steam turbine ?
2 Answers Bhushan Power Steel, MSP,
how to select the capacity of an exhaust blower( exhaust booth) in an automobile industry.
How do you control cylinder liner wear?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)