Interested to Buy Any Domain ? << Click Here >> for more details...
In a Waste heat recovery boiler feed control valve is after
the economiser where as in auxilary boiler feed control
valve is given before the economiser.why?
- 2 Answers
- 7506 Views
- I also Faced
- E-Mail Answers
Answer Posted / magesh
Where have you seen a Feed Control Valve after Economiser in
WHRB?
If it is located after economiser, there is no purpose in a
feed control valve. Usually feed control valves are placed
before economisers in all boilers, so that feed water can be
controlled according to the power requirement. Once it
enters Economisers directly it will go through drum. We
cannot control thereafter. If u still need any explanations,
just mail me mageswaran.c@gmail.com
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Name any four commonly used refrigerants.
what is draft and draft loss?in a boiler,how is draft created?
what is fullform of ge 9ea gas turbine
what will be the minimum bearing clearance that after it will not profitable for machines?
Dear Friends I want to previous 5-10 years technical and non tech. question paper of section engineer (mechanical)of RRB and also tell me how should I prepare for S.E. and which books will help me for technical,aptitude,resoning.plz send me at bkcs.bkcs@rediffmail.com
Which factors influence the type of fracture in failure of a material ?
What are the things needed to have an efficient boiler burning?
dear sir i m anshul kumar from dehradun i want to last five year railway chandigarh and allahabd entrance exam papers pls send it on my id my id is anshuldhiman83@gmail.com or anshuldhiman@rediffmail.com i shall be very greatful to u thank u
how hydraulic power stearin clutch work plz explain
What happens when too much cylinder oil is injected in the working cylinder?
What is the use of outside micrometer?
What is the difference between projectile motion and a rocket motion?
draw neat sketch of pirani gauge with wheatstone bridge circuit to measure output. discuss its construction working princple
what should be sensor sensitivity of accelerometer in vibration? And what is the main difference between accelerometer and proximity sensors and others?
Give an introduction to bourden pressure gauge?
