In a single phase converter, the no. of SCR conducting during overlap? a.1

In a single
phase converter, the no. of SCR conducting during overlap?

a.1 b.2 c. 3 d. 4

Question Posted / srikanth

3 Answers
10064 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In a single phase converter, the no. of SCR conducting during overlap? a.1 b.2 c..

Answer / bala

b)2

Is This Answer Correct ?

21 Yes

5 No

In a single phase converter, the no. of SCR conducting during overlap? a.1 b.2 c..

Answer / sohaib siddqiue

d.4

Is This Answer Correct ?

11 Yes

5 No

In a single phase converter, the no. of SCR conducting during overlap? a.1 b.2 c..

Answer / niraj kumar

d. 4

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m

0 Answers

Slip at maximum torque depends on A rotor resistance and reactance B stator reactance C load current D stator resistance

1 Answers

what is CT class? depending upon which it is classified?

3 Answers Siemens,

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers

what is meant by fuzzy logic? what is fuzzification and defuzzification?

5 Answers MEIL, Power Grid,

How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?

0 Answers

WHAT IS DIFFERENCE BETWEEN POTENTIAL DIFFERENCE AND E.M.F?

2 Answers

In which connection the voltage will be more , in star or delta connected motor?

3 Answers

What is mean by sink and source in term of PLC and drives,where and how they used in logic

2 Answers

What will happen if mains neutral and generator neutral shorted?

2 Answers Betts, Suzlon,

define ac reactor? thier application;

1 Answers

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers

For more Electrical Engineering Interview Questions Click Here