Answer / p k ajeshkumar

Connecting a capacitor across a generator always improves
powerfactor,but it will help depends up on the engine
capacity of the alternator,other wise the alternator will
be over loaded due to the extra watts consumed due to the
improvement on pf. Secondly, don't connect a capacitor
across an altenator while it is picking up or without any
other load.

Answer / loki

cap connected across the load improves operating pf

Answer / b.ramesh

When capacitors connected across the DG load that there was
harmonics devoloped.That harmonics will be effect on DG
alternator and excitor to cause of winding failure.

Answer / phanendra babu

if we connect the capacitor across the alternator for
compensating the inductive load it will be more use full,
improves the p.f hence reduces the load on the Altrnatr. if
it is under no/light load condition,alternator output
voltage will increase more than the rated,hence connected
load will be effected and hissing noise will observe from
the alternator,hence it will effect the efficiency and life
of the alternator

Answer / nithiyanandam

cacitor act just like load.

i wasted one year for the job after completed my btech what can i say about 1year time in interview

0 Answers   Infotech,

fundamentals of transformers.

5 Answers   Adani,

what is difference between AC VVVF drive & Dc VVVF drive explain their working principle?

13 Answers   Apollo, OPS,

It is advisable 2 use auto-transformer if transformation ratio is-a)110KV/11KV,b)230kv/110kv,c)110kv/66kv,d) 400kv/230kv

2 Answers  

how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)

0 Answers  

Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..

2 Answers  

How to calculate cable size by using load.?? Any formula...

0 Answers  

transformer 3 ph, 225 kva pri 480v, sec 208v. primary neutral connected to system, is secondary neutral to be grounded and how

1 Answers  

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers   Air Force,

WHAT IS THE REASON FOR THE GROUND PIN IS BIGGER IN SIZE COMPARING TO OTHER PINS?

13 Answers  

What is meant by regenerative braking?

5 Answers  

OHMS Law is only applicable for ac or dc or both circuiT?.

6 Answers