what the purpose of protection signaling equipment in substation?

what the purpose of protection signaling equipment in
substation?

Question Posted / gtmanikandan

2 Answers
9721 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what the purpose of protection signaling equipment in substation?..

Answer / zizo

PSE act as isolator between protection equipment and
communication cloud.

Is This Answer Correct ?

2 Yes

0 No

what the purpose of protection signaling equipment in substation?..

Answer / dinesh

Protection signal(Pulse) helps to act the relay to trip
and disconnect the equipment from the damage,

Is This Answer Correct ?

3 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.

0 Answers

WHAT IS THE MINIMUM IR VALUE FOR CABLE CHARGING

4 Answers Google,

If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these

0 Answers

what is bushing in transfermor

7 Answers Bokaro Steel, Visa Steel,

what percent do you derate your copper wire when you change from copper buss to copper wire

0 Answers Gerdau,

can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

6 Answers TCL,

Is it necessary to carry out sheath test after cable jointing? If the value is zero of such instance , is it ok to energize the cable?

1 Answers

which bridge is used to measure frequency?

2 Answers

Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?

0 Answers HCL, Reliance,

what do you mean by leading power factor & lagging power factor

13 Answers Suzlon,

A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?

0 Answers

Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,

0 Answers

For more Electrical Engineering Interview Questions Click Here