What is maintenance planning?
Answers were Sorted based on User's Feedback
Answer / james
A short definition of maintenance planning and scheduling:
Planning decides what, how and time estimate for a job. Scheduling decides when and who will do the job. Planning of a job should be done before Scheduling a job.
Is This Answer Correct ? | 14 Yes | 0 No |
Answer / guna
Maintenance planning is nothing but to plan the maintenance.
correct priod of maintenance
To maintain machine history card is very important for
maintenance. There are i.preventive
ii.break down.
Is This Answer Correct ? | 28 Yes | 17 No |
Answer / ashish dushing
MAINTENANCE PLANNING IN AVIATION IS TO PREPARE WORKPACK FOR
AIRCRAFTS WITH THE HELP ATA CHP 5 FOR MAINTENACE,IT ALSO
DEAL WITH LOG BOOK ENTRIES ,PREAPARATION OF DUE
LIST,AMP,WORK ORDER,CHECK AVAILABILTY OF SPARE/CONSUMABLES
FOR SHEDULE ,UNSHEDULE MAINTENACE WORK,MEL.RELATED TO OTHER
CERTIFICATES SUCH AS COFA,ARA ETC.
Is This Answer Correct ? | 4 Yes | 10 No |
how to measure low temperature(<100 dec celsisus) with non condact sensor
what is full form of SMART
46 Answers Infosys, ITC Infotech, Lanco, Rosemount, Solvay,
how to replace the smart transmitter software
Absolute pressure is 700psi,what will be the gauge pressure?
How to adjust the zero & span of a control valve from the posiitioner(MIL)?
where is a level displacer is used?
how can check the loopchecking for valves?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
if i want buy a pressure gauge then witch parameter i look
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
1. Pl. send details about different types Gas Analyser, like Co2, O2, SOX/NOX, etc. with calibration procedure. 2. How to calibrate H2S gas detector in field?
Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify