how we can find of current direction(supply comming/out
going direction) when a transmission line passing through
sides.
No Answer is Posted For this Question
Be the First to Post Answer
WHY WE USE SIEMENS plC
How Kneepoint voltage of CT practically related when CT in service. ie Knp is above 670 what exactly means
Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
Why short circuit calculation is not required in LT cable sizing and requiredin HT cable sizing only
what is the difference between KVAR & KVA ?
11 Answers Bombay Rayon Fashions, Hyundai, Pricol,
Explain briefly about current , voltage and power
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
Generator protection &generator test
In a star-star connected h.t transformer why we use NGR on the secondary (l.t)side.
WHAT IS THE DIFFERENCE BETWEEN UNDERVOLTAGE COIL, CLOSING COIL AND SHUNT TRIP COIL OF AN ACB?
What meant by XLPE cable
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)