Answer / virendra

because the reactive prower produce by the Capcacitor may
harm the AVR of the DG set

Answer / kadiresan.k

whether the load is on EB or DG, p.f to be maintained close
to unity and the type of load to be studied and capacitor
to be connected accordingly. The Capacitors to be switched
ON and OFF according to the load with the help of APFC
panels / Controllers. In case of load shedding time, the
concerned capacitors to be tuned off immediately, else it
will result in over voltage at the system if the load is on
DG side. So the power system to be optimised to handle the
load in both EB and DG with proper power factor correction
systems.

Answer / william lobo

By putting capacitor on Genset what we are doing is only
loading the genset additionally.
Capacitor is used to improve the power factor of the
system. This is important for the power supply cos; hence
they insist that pf should be 0.9 or thereabout.
Hence it is compulsory to use Capacitors to improve the PF
if below 0.8 or they will fine you.
When using a gen set we have to see what is the type of
load. If it is motor load inductive then we have to switch
on some of the capacitor banks only.

what is two wattmeter test

2 Answers   Jindal,

---

What do you mean by cold shinkable cable joint.How it is done.

0 Answers  

---

what are the materials used in HRC fuse

3 Answers   Bhel,

---

what is earthing

1 Answers  

---

what type of insulation is used for over head lines?

4 Answers   NTPC, WS,

---

why capacitor bank shorted by resistance ( 3 terminal )

1 Answers  

---

We know no of electron and proton in atom but how many Neutron are thire in an atom ?

1 Answers   Power Grid,

---

can induction motor run over the rated speed ?

12 Answers   ACC,

---

What is the specification of service line (ie from electrical post to cut out) used by electricity boards used in india.i mean which material,its size etc.. please give the answer at lalkishan.p@gmail.com

0 Answers  

---

what condition there autotransformer will fail?

2 Answers  

---

what happen "when Dyn11 is parallel operation with Dyn1"?

9 Answers  

---

How to calculate the slip ring induction motor rotor current and voltage.

1 Answers   Bhel,

---