Answer / sunil parmar

CARGO--cold rolled grain oriented is used as a core of
x'mer it reduces the cu loss,iron loss,low hysteresis loss
ie. magnetization and demagnetization losses ,increases
permeability,and it reduces the excitation current required
to maintain the flux level and therefore increases the
magnetic strength of x'mer........

for any disagreement reply me on parmar20072008@yahoo.com

Answer / tinku

CRGO is the material used to make up the core of
transformer. it is mainly used to provide better magnetic
permiability with less excitation currents

Answer / dgf

to reduce the iron losses

Answer / gunasekaran

high permeability and low hysteresis loss high saturation
point for core lamination.

Answer / vdd

To develop the magnetic flux

Answer / atul zarbade

it reduce the core losses and excitation current. increase
the permeability.

after applying C-License in how many days we get it?

2 Answers  

What will be the average KVA rating of Auto Transformer for 75kw 415V , 3phase induction motor

2 Answers  

How to check maintenance free battery 12V,26AH using analog multimeter

1 Answers  

sir, plz tell me how much kvar capacitor required for 1000 amp or 500 Kw load ? what is the formula ?

14 Answers   CSPL,

Diff between power trans and generating transformer?

1 Answers  

What do you mean by a phase angel of instrument transformer?

0 Answers  

Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com

0 Answers  

what about SAP/MRP regarding manufacturing of electric motors and all drives?

0 Answers  

for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance

0 Answers  

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers  

What is the size of cable to be used for a Space Heater in UPS 160KVA of carrying 10 Amps current with 240 V ,1 Phase?

3 Answers  

WHY HVDC?

3 Answers