Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sunil parmar
CARGO--cold rolled grain oriented is used as a core of
x'mer it reduces the cu loss,iron loss,low hysteresis loss
ie. magnetization and demagnetization losses ,increases
permeability,and it reduces the excitation current required
to maintain the flux level and therefore increases the
magnetic strength of x'mer........
for any disagreement reply me on parmar20072008@yahoo.com
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
give me a clear defination of inductance,and how can u calculate inductance of a motor
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
why electronic instruments is more favorable than electrical?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
How can a equal potential zone be carried out in conductors?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
show the single line diagram of star delta starter with single phase preventer
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
Is Transol transformer oil comparable to nynas nytro libra?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
Write down the brushes of a de machine.
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
