Answer / mahadeva

Cutt off the power supply and take the megger and test the
insulation restance between two lines or conduct the short
circuit test between conductors then then rectified the
fault

Answer / bond

Budhaa lal should be named as Budhuu Lal the great ...
fools should not speak if they dont know the ABCD of
electrical engineering.

Answer / satish

open the circuit breaker and rectify the fault

Answer / budhaa lal the great

for line to line fault open the bus chamber and hold the
two phases with your hand u will get line to line fault and
also feeling of it.

What is restricted earth fault protection ?

1 Answers  

---

when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//

0 Answers  

---

How to check op amp using multimeter

1 Answers  

---

PRV (Pressure relief valve) Trip with oil splash outside power transformers

1 Answers   Khan,

---

When alarm is activated in buccholz relay in transformer

1 Answers  

---

What is cable size of motor if starting current is 15.6 Amperes??

0 Answers  

---

In LT Line What is the minimum clearance required between phase to phase busbar & between Phase to body of the panel? Also between Neutral &phase, & Neutral & body of panel. as per standards.

1 Answers  

---

what are the interview question asked in wind mill about electrical

0 Answers  

---

how to determine motor size for a fan application?

0 Answers   EDC,

---

MCB Rating

1 Answers  

---

in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks

0 Answers  

---

We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.

0 Answers  

---