Answer Posted / satish
open the circuit breaker and rectify the fault
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
where rlc series ckt used?
how 650 volts creates? where is use?
Why the magneti fields are not passes from southpole to north pole
how many single tension hardware are required on a double circuit transmission tower?
what are the possible reaons & remedies if resistance of NGR getting heat up
can i use 2000/5A Clamp meter to measure HT cable
what is the illumination level required for child play area?
what is stper motor
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
what is high and low cut off voltage of BB and DG at SPS????????
What is the purpose of stablization resistor in high impedance bus bar protection
please send me previose rrb junior engineer qustion papers
