What_is_mean_by_negative_dc_voltage? why we use -48v except
+48v in DC power supply systems.
Answers were Sorted based on User's Feedback
Answer / er. ankush miglani 9718151073
IF WE CONNECT THE +VE POLARITY TO THE EARTH AND -VE TO THE
EQUIPMENT THE VOLTGE IS CALLED -VE DC VOLTAGE.
THE POSITIVE POLARITY ACQUIERS THE CORROSION VERY QUICKLY
AND TO MAINTAIN THE VOTAGE OF THE DEVICE UNDER
SPECIFICATIONS IT IS DONE.
Is This Answer Correct ? | 10 Yes | 1 No |
Answer / sadat khan
we use -48voltd.c instead 0f +48voltd.c because all
problems like fluctuvation,surges all occur in possitive
wire not in negative wire.
Is This Answer Correct ? | 1 Yes | 2 No |
hoe to select the cable size in sq mm for certain load?
how to mention 5mw generator in kva ? gen voltage is 11kv
In a three phase transformer(delta/star connected)when i touch one end of the bulb in any one phase and other end to earth..will the bulb glow or not..if not why?..i'm touching the bulb in star connected side...
What is the difference between earthed and unearthed power cable.
send me all basic electrical question and answers
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
in india,we use 230V,50 Hz,whereas many other countries use 110V,60Hz.what r d advs and disadvantages of each of them?
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
how to identify 3phase....r y b .A new make altnator how to identify R
What are the test performed on A faulty transformer ?
whatis knee point ?
IN PLATE EARTHING , PLATE LAID IN VERTICAL POSITION ,WHY HORIZONTAL WHY NOT