Answer / shahulsnfa

yes the motor will run.. but u will not get the rated
torque of the motor since voltage is directly proprtional
to torque.

Answer / kishor mahale

yes motor will run, but motor will not get rated torque and
speeds. because torque is directly proportional to current,
and speed and torque are inversely proportional.

Answer / jignesh kadia

yes, motor will run with lesser torque & speed..but after
some time it's get overheated because of they run under
exited condition.the emf not much produce to rotor cause
rotate at rated speed so that humming produce in it. the
losses are produce in motor and it's get overheated.. and
motor will burn out..

Answer / suhas

yes, it will run.... since voltage is lower, to maintain
the output power to its rated capacity it draws more
current...due to which the windings get heated and burnout
will take place....

Answer / er. dattesh shah

YES MOTOR WILL RUN WITH LESSER SPEED THEN OTS RATED SPEED.

Answer / suresh kumar

Motor will run with lesser speed and torque. But if the
load is same as in the case of 230VAC, current will be more
and motor may burn.

Answer / bharath

emf will not build up induce sufficiently in order tolock
the rotor slots

why we r using alternator instead of d.c generator and induction generator

1 Answers  

we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards

0 Answers  

how to test power transformer.YNd11

0 Answers  

What is the difference between RMS and average value

5 Answers   CEERI, HPCL,

where is the primary of CT??

3 Answers  

What happens if the secondary of the transformer is shorted?

2 Answers  

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers  

why number of stator and rotor slots are not equal in IM?

1 Answers  

What is the formula to calculate the rating of a three phase miniature circuit breaker

0 Answers  

what is the use of vector group in transformer. means what r the application of various vector groups?

5 Answers  

The power supplied to a 33microF capacitor from a 120V, 60Hz source will be

0 Answers  

ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine

0 Answers