The ability to draw wires is called
Answers were Sorted based on User's Feedback
Answer / himanshu lohani
The answer is ductility..................
Malleability is indeed the ability to draw into thin sheets......
| Is This Answer Correct ? | 61 Yes | 9 No |
Answer / shiva
ductility. that means ability to withstand high tensile
force (this is the actul definition)
whereas malleabilty means ability to withstand high
compressive force ( that is the ability to drawn into thin
sheets)
| Is This Answer Correct ? | 29 Yes | 3 No |
Answer / vijay
the ability to draw wire is Ductility
malleabity is flatten to sheets...
| Is This Answer Correct ? | 21 Yes | 6 No |
Answer / naseeb ahmeds
Ductility is a property of material which can absorb tensile
forces without break thats why they used in wire drawing
purpose.
Malleability is for compressive strength
| Is This Answer Correct ? | 10 Yes | 2 No |
Answer / pjagan89
the ABILITY TO DRAW WIRES is CALLED DUCTILITY.
Malleability is the ability to draw wires into thin sheets.
Answer: DUCTILITY
| Is This Answer Correct ? | 7 Yes | 0 No |
Answer / k. murali
The ability of material drawn into wire is called ductility
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / naresh
its is ductility as malleability dealsindrawing sheets
| Is This Answer Correct ? | 6 Yes | 3 No |
Answer / vivek kumar srivastava
malleabity is the property of material and ability to drawn
the wire
| Is This Answer Correct ? | 1 Yes | 8 No |
HRSG
What is the differences between IC & EC Engines.
How do you define mechanical efficiency in case of compressor? How it is different that of an IC engine?
IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE INDIVIDUAL SHAFT FOR EACH TURBINE....?
sir, I am applied RRB chennai,MMV(mechanical),Pls mail 2006,2007 & 2008 years solved question papers.My Mail jrks@rediffmail.com
How does turbine work?
How can i Check at site this material is Powder coated CRCA ?
0 Answers Bouygues Batiment International, Essar,
Who built the first rocket that robert goddard invented?
what is air standard efficiency of a cycle?
Explain how does hydraulic clutches work?
What is cutt off ratio in IC Engines.give proper defination.
5 Answers Essar, Hyundai, Jindal Steel and Power, L&T,
what happen when there is moisture in the TX valve?rac
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)