Interested to Buy Any Domain ? << Click Here >> for more details...
a voltmeter shows 100v..wat is to be done to make it read 150v.
- 7 Answers
- 15185 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / madhusudhana
To increase Ammeter range, we add shunts and to increase voltmeter range, series resistance is connected to it. The device is calibrated accordingly.
| Is This Answer Correct ? | 17 Yes | 0 No |
Answer / praful nandankar
Resistor is added in series to increase the voltmeter range.
| Is This Answer Correct ? | 8 Yes | 1 No |
Answer / tinku
if you want to make the deflection of voltmeter on 150 volt
on appling 100 V you can reduce the series resistance of
voltmeter it will cause more current to folw through it and
will show more (false) reading. But if you actually want to
increase its range to 150 volt i.e. it can measure upto 150
V you have to increase the series resistance
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / latha
increase the number of turns in the pressure coil
| Is This Answer Correct ? | 3 Yes | 6 No |
Answer / manoj sharma
Ther are following solutions.
1. increase the souce voltage up to 150V, which is being
measured by voltmeter.
2. volt meter measure the voltage by a niddle which is
clibrated to show difflection acording to magnetic force
develored in the potential coil. So increase the number of
turns up to 1.5 times of present no. of turns.
3. Replace the potential coil with new coil having
inductance 1.5 times of present potential coil.
Any way but why you want to do so.....plz tell me geetha...
| Is This Answer Correct ? | 0 Yes | 3 No |
What is resolution of a measurement?
How to measure the Harmonic Distortion of UPS ie THD?
what is meant by phase &line voltage, how its differ from each other ?
What is Phasing out test?
what is inrush current in transformer?
17 Answers Bhel, Essar, GMR,
what is the difference b/w conductor and semicoductor
basic of electrical information where i can get? plz send the website which you know?
How do you commission a power Transformer?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
why the power factor is low at no load?
what is raw power & normal power
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
