WHAT IS THE MEANING OF 'UPF'&'LPF'.... HOW CAN WE DEFINE IT?
WHAT IS THE VALUE/RANGE OF EARTH WIRE RESISTANCE USED
PARTICULARLY IN HOME....
Answers were Sorted based on User's Feedback
Answer / praveen jkumar sharma
unity powerfactor:when voltage and current are in same
phase i.e displaced by zero degrees simply cos(phy)=1;
where phy is the phase angle b\w voltage and current
low power factor: when current lags behind voltate by angle
phy,usally cos(phy)=0.1 to 0.4 corresponds to low power
factor
earth resistance varies from 2 to 5 ohm.
| Is This Answer Correct ? | 25 Yes | 4 No |
Answer / dilse
unity powerfactor:when voltage and current are in same
phase i.e displaced by zero degrees simply cos(phy)=1;
where phy is the phase angle b\w voltage and current
low power factor: when current lags behind voltate by angle
phy,usally cos(phy)=0.1 to 0.4 corresponds to low power
factor
| Is This Answer Correct ? | 21 Yes | 4 No |
What is the need of ISOLATION Transformer?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
If R and Y terminals are short circuited,then power will cut. we all know that power cannot be stored.what will happen to already generated power at power station?
What is the importance of setting TSM & PSM?
What type of tranformer generaly at soft wares like capacity 2000 kva 1800 kva etc iam confused it CT or PT OR distribution tranformer
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
What is the difference between Isolator annd Circuit Breaker.
21 Answers ABB, Lanco, NTPC, Power Grid, RInfra,
For a Potential Transformer(PT), the primary neutral terminal must be grounded before energization. Why....? What will be heppend if we energize the PT without grounded the primary neutral point? Why..........?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
is there a different b\w ground fault CB and earth leakage
Why HT motor is connected in Star?
Why earthing transformer used in Distribution Sub-Station?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)