Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE MEANING OF 'UPF'&'LPF'.... HOW CAN WE DEFINE IT?
WHAT IS THE VALUE/RANGE OF EARTH WIRE RESISTANCE USED
PARTICULARLY IN HOME....
- 2 Answers
- 22973 Views
- I also Faced
- E-Mail Answers
Answer Posted / dilse
unity powerfactor:when voltage and current are in same
phase i.e displaced by zero degrees simply cos(phy)=1;
where phy is the phase angle b\w voltage and current
low power factor: when current lags behind voltate by angle
phy,usally cos(phy)=0.1 to 0.4 corresponds to low power
factor
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
Difference between megger test equipment and contact resistance meter test instruments?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
What is A check, B check, C Check & D check for a diesel Generat
Starting current of a 10 HP induction Motor is ______ time’s full load current.
What is the meaning of loop in transformer
List the disadvantages of constant k filters?
orifice sizing how done, checking & selection
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What are the advantages of vscf wind electrical system?
what is harmonics? what are the factors it will depend upon
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
