Answer / s.madhavan

Thumb rule : KVA X 1.4 = Full load current/ per phase @ 0.8 p.f

Answer / mallikarjun

I=KW/SQRT3*V*0.08

Answer / heamkumar

I = KVA / (sqrt 3 * Voltage)

Answer / k.gurusamy

P=√3*V*I*0.8
P in KW
V=415V
I=?
ANS:
P=1.732*415*I*0.8
KW =575.024*I
KW/575.024=I
I=(0.00174*KW) AMPERE

electrical

0 Answers   BSES, Minda,

---

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers  

---

dear all, in motor operation , motor is of 100 hp and bimetal relay setting is 130 amp, if relay is getting tripped on 120 amp balance current what can be the reason? Relay is newly replaced. I dont know but is there any frequency effect in thit case? Can frequency variation affect bimetal relay operation?

1 Answers  

---

how to calculate the earthing conductor & no. of earth pits required

3 Answers  

---

Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)

0 Answers  

---

how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

0 Answers  

---

Explain cmrr?

0 Answers  

---

why transmiision rating in kva?

4 Answers  

---

ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com

0 Answers   KBC, wbsedcl,

---

what is non uniform load

1 Answers  

---

In a Tap changing transformer where is the tap connected , is it connected in the primary side or it is connected in secondary side

8 Answers   Indiabulls,

---

what is the Space heater? why using in Electrical motor?

3 Answers  

---