Answer / ganga bhavani

these terms are used in control systems.we know that the open loop control system should have high sensitivity then closed loop control system.stability is the parameter which tells the performance of a system.

How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.

0 Answers  

---

if we use fuse in neutral what will happen?

9 Answers   L&T,

---

Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??

0 Answers  

---

when we change tha taps from 1-16 in 100mva tr whether a constant voltage avaliable till it reaches tap 16 or voltage change as per taps change

1 Answers  

---

What is a compensator?

0 Answers  

---

why single phase to grd test in HV cable?why not 2 phase at a time?

0 Answers  

---

if we know Fault level say 25 KA , How to decide busbar size for Distribution network of 1000 Amp Breaker ? Sample Calculation or Farmula Available or not ?

4 Answers   TCS,

---

what is the use of earthing?

1 Answers   CPCL,

---

Write the difference between OCB,VCB ?

3 Answers   Svam Power,

---

In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?

0 Answers  

---

What is sinusodial & non sinsodial current

1 Answers  

---

Why not implimenting power factor in Diesel generator

6 Answers   HP,

---